Welcome to KillTest.com
 About JN0-104 Questions

TOP Exams

Want to practice some free Juniper JN0-104 exam questions? You can study the following Juniper JN0-104 exam online questions. Killtest provides 142 Q&As for Juniper JN0-104 exam, which has been proven effective in the JN0-104 exam preparation. Besides, you can get full payment fee refund if you fail JN0-104 exam by using Killtest JN0-104 practice exam questions. Ready? Go!

 Get JN0-104 with 142 Q&As

Juniper JN0-104 Online Practice Exam Questions

The questions of JN0-104 were last updated on Aug 16,2023 .

Viewing page 1 out of 28 pages.

Viewing questions 1 out of 142 questions

Question#1

Which of these about transit traffic is true?

A. Traffic that enters an ingress port, is compared against the forwarding table and forwarded out an egress port.
B. Traffic that is addressed to the chassis, requires special handling by the RE before it can be forwarded out an egress port.
C. Traffic that requires special attention and does not pass through the device.
D. Traffic that generates an ICMP message.

Question#2

You are at the top of the hierarchy and you must configure OSPF on interface ge-0/0/0 unit 1.
Which of these will achieve the result? (Choose two)

A. [edit] user@router# set protocols ospf area 0 interface ge-0/0/0.1
B. [edit] user@router# set protocols [edit] user@router# set ospf area 0 [edit] user@router# set interface ge-0/0/0.1
C. [edit] user@router# edit protocols
D. [edit protocols] user@router# set ospf area 0 interface ge-0/0/0.1 [edit] user@router# edit protocols ospf interface ge-0/0/0.1

Question#3

Which of these is true when the following command is issued?
ping interface ge-0/0/0 192.168.1.1 bypass-routing count 1000 rapid

A. The count parameter creates a counter that you can view with the show firewall command.
B. The count parameter allows the router to send out 1000 pings and then stop.
C. The count parameter allows the router to pause for 1000 seconds before sending a ping.
D. The count parameter allows the router to count the number of pings for logging purposes.

Question#4

The following is the output of the show system alarms command.



Which of these commands will resolve the problem shown above?

A. file save current /config/rescue.conf
B. file copy current /config/rescue.conf
C. request system configuration rescue save

Question#5

Which of these commands can be used to delete unnecessary files and free up disk space on the Junos device?

A. user@router> request system storage remove
B. user@router> request system storage cleanup dry-run
C. user@router> request system storage delete
D. user@router> request system storage cleanup

Exam Code: JN0-104
Q & A: 142 Q&As
Updated:  Aug 16,2023

 Get JN0-104 Full Version

KILLTEST CONTACT INFO

[email protected]

GMT+8: Mon-Sat 8:00-18:00

GMT: Mon-Sat 0:00-10:00

Certifications

How to buy

Stay in touch